Throttle position sensor replacement
Get quotes for your Holden Calibra from independent specialists near you.
Australia's #1 booking site for car services & car repairs
Book now, pay later Interest-free payments
Transparent prices no surprises
*Available at select service providers. T&Cs apply.
Holden Calibra Throttle position sensor replacement
How much does a Holden Calibra throttle body sensor replacement cost?
An internal combustion engine requires a mixture of air and fuel to provide the energy for combustion. The air-to-fuel ratio needs to be correct for your Holden Calibra’s engine to run smoothly and to deliver a prompt response to your driving throttle demands.
The amount of throttle being requested by the driver is monitored by a throttle position sensor (TPS) which determines the airflow through the Holden Calibra’s throttle body. The throttle position sensor plays a crucial part in the Holden Calibra’s engine management system and if it fails, the check engine light may appear and you may notice engine misfire and/or poor performance.
The throttle position sensor is usually situated next to the Holden Calibra’s throttle body. In some cases, it connects with the butterfly spindle to monitor the throttle position. However, on ‘drive-by-wire’ or electronic throttle control (ETC) systems it can also control the throttle position. It controls the rate and volume of airflow into the engine.
Anytime the air/fuel mixture might be incorrect on a Holden Calibra it is a cause for concern and the problem should be rectified as soon as possible. There is the chance of engine damage if this issue is left for too long, and driving an unhappy Holden is never a relaxing drive.
